replacements for Pushmatic Circuit Breaker
UBI Type P replacement circuit breakers are suitable as
replacements for Pushmatic circuit breakers. They are
suitable for use in ordinary locations only, and with
Pushmatic panel boards only.
A representative sample of the UBIP Series was tested in
accordance with the National Electric Code and the Standard
for Molded-Case Circuit Breaker Enclosures.
The following tests were performed:
200% Calibration at 25 degrees C, 135% Calibration at 25
degrees C Overload, Tungsten Lamp Load, 100% Calibration at
40 degrees C, Endurance, Interrupting Ability, 200% trip-out
at 25 degrees C and Dielectric Voltage Withstand.
* Single Pole
* Double Pole
* Twin Pole
* 10,000 Amp Interrupting Rating
* HACR and SWD Rated
A representative sample of the UBIP Series has been
evaluated and found to comply with the applicable
requirements of the Standard for Molded-Case Breakers and
Circuit Breaker Enclosures, as required be the National
*Pushmatic is a registered trademark of Siemens Energy