Thin Single Pole TYPE NC Interchangeable Brand (View)

Thin 2 Pole TYPE NC Interchangeable Brand

Thick Single Pole TYPE NA Interchangeable Brand

Thick 2 Pole TYPE NA Interchangeable Brand

Thin Single Pole TYPE NC Original Brand

Thin 2 Pole TYPE NC Original Brand

Thick Single Pole TYPE NA Original Brand

Thick 2 Pole TYPE NA Original Brand

ALL BREAKERS BELOW ARE ORIGINAL BRAND ONLY

Single Pole GFCI Circuit Breakers

3 Pole Plug In Circuit Breakers

UBIF Replacement Circuit Breakers Product Data:
UBI Type F replacement circuit breakers are suitable as replacements for Federal Pacific Electric circuit breakers. They are suitable for use in ordinary locations only, and with Federal Pacific Electric panel boards only.

Test Performance: A representative sample of the UBIF Series was tested in accordance with the National Electric Code and the Standard for Molded-Case Circuit Breakers Enclosures, (ANSI/UL 489, 9th Edition). The following tests were performed: 200 percent Calibration at 25 degrees C, 135 percent Calibration at 25 overload, Tungsten Lamp Load, 100 percent Calibration at 40 degrees C, Endurance, Interrupting Ability, 200 percent trip-out at 25 degrees C and Dielectric Voltage Withstand.
Product Style:
Single Pole: Thin 1/2" and Thick 1"
2 Pole: Thin 1" and Thick 2"
HACR and SWD Rated
10,000 Amp Interrupting Rating

Conclusion: A representative sample of the UBIF series has been evaluated and found to comply with the applicable requirements of the Standard for Molded-Case Breakers and Circuit Breaker Enclosures (ANSI/UL 489, 9th Edition), as required by the National Electric Code.
*Federal Pacific Electric is a Registered Trademark of American Circuit Breaker Corp.